Sienna FWD V6-3.3L (3MZ-FE) (2006)
5. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
a. Engage the 16 clips to install the front quarter trim panel assembly.
b. Connect the courtesy light connectors.
c. Install the courtesy light.
d. Install the 2 package holder net hooks.
e. Install the No. 2 rear seat outer belt assembly on the floor anchor side with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
NOTE: Do not make the anchor part run onto the protrusion part of the floor panel.
f.
Install the floor anchor cover.
g. Check the ELR lock.
NOTE: The check should be performed with the assembly installed.
6. INSTALL BACK DOOR SCUFF PLATE
7. INSTALL BACK DOOR WEATHERSTRIP
8. INSTALL REAR DOOR WEATHERSTRIP
9. INSTALL REAR DOOR SCUFF PLATE
Rear Center Seat Inner Belt Assembly
REMOVAL
1. REMOVE CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
a. Remove the bolt and center seat lap type belt assembly.
2. REMOVE CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
-
Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
-
Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
a. Remove the bolt and center rear No. 2 seat lap belt assembly with inner.
3. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
-
Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
-
Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
a. Remove the bolt and rear No. 2 seat belt assembly inner.
INSTALLATION
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
a. Install the center rear seat lap type belt assembly with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)