Sienna FWD V6-3.3L (3MZ-FE) (2006)
2. INSTALL CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
-
Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
-
Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
a. Install the center rear No. 2 seat lap belt assembly with inner with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
3. INSTALL REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
-
Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
-
Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
a. Install the rear No. 2 seat belt assembly inner with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
Rear Center Seat Outer Belt Assembly
REMOVAL
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).
a. Remove the rear seatback board.
b. Remove the rear seat shoulder belt cover.
c. Remove the 2 bolts, 2 nuts and No. 1 rear seat outer belt assembly.
2. REMOVE 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
a. Remove the roof headlining.
HINT: Refer to the instructions for removal of the roof headlining.
b. Remove the 2 bolts, 2 nuts and 3 point type No. 2 rear seat belt assembly.
INSTALLATION
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
a. Check the degree of tilt when the belt begins to lock the ELR.