Sienna FWD V6-3.3L (3MZ-FE) (2006)
Alternator: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
1. REMOVE GENERATOR PULLEY
SST 09820-63010 (09820-06010, 09820-06020)
a. Hold SST 1-A with a torque wrench, and tighten
SST 1-B clockwise to the specified torque.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
NOTE: Check that SST is secured to the rotor shaft.
b. Clamp SST 2 in a vise.
c. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.
d. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
NOTE: To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.
e. Remove the generator from SST 2.