Sienna FWD V6-3.3L (3MZ-FE) (2006)
22. REMOVE REAR DRIVE PINION REAR TAPERED ROLLER BEARING
a. Using SST and a press, remove the rear bearing from the drive pinion.
SST 09950-00020
HINT: If either the drive pinion or ring gear is damaged, replace both as a set.
b. Remove the plate washer.
23. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
a. Using a brass bar and a hammer, remove the front bearing (outer race) from the carrier.
24. REMOVE REAR DRIVE PINION REAR TAPERED ROLLER BEARING
a. Using a brass bar and a hammer, remove the rear bearing (outer race) from the carrier.
25. REMOVE DIFFERENTIAL RING GEAR
a. Align matchmarks on the ring gear and differential case.
b. Using a screwdriver and a hammer, unstake the 4 lock plates.
c. Remove the 8 ring gear set bolts and 4 lock plates.