Sienna FWD V6-3.3L (3MZ-FE) (2006)
26. INSPECT DIFFERENTIAL CASE ASSEMBLY
a. Install the differential case to the differential carrier.
b. Install the right and left bearing caps with the 4 bolts.
Torque: 79 Nm (800 kg-cm, 58 ft. lbs.)
c. Using a dial gauge, measure the differential case runout.
Maximum case runout: 0.07 mm (0.0028 inch)
d. Remove the differential case.
27. REMOVE REAR DIFFERENTIAL CASE BEARING
a. Using SST remove the case bearing (LH) from the differential case.
SST 09950-40011 (09951-00240, 09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011),
09950-60010 (09951-00360)
28. REMOVE REAR DIFFERENTIAL CASE BEARING
a. Using SST remove the case bearing (RH) from the differential case.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011), 09950-60010
(09951-00360)
29. REMOVE REAR DIFFERENTIAL PINION SHAFT
a. Using a pin punch (5 mm) and a hammer, remove the straight pin.