Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-1889004.png)
3. INSTALL WINDOW GLASS ADHESIVE DAM
a. Coat the installation part of the windshield glass adhesive dam with Primer G.
NOTE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not apply too much Primer.
b. Install a new dam, applying double-sided tape all the way around the glass except where the stoppers are installed, as shown in the illustration.
4. INSTALL WINDSHIELD MOULDING OUTER UPPER
a. Using the brush or sponge, coat the edge of the glass and the contact surface with Primer G.
NOTE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not coat the adhesive with Primer G.
-
Do not keep any of the opened Primer G for later use.
b. Install the moulding.
5. INSTALL WINDSHIELD GLASS
a. Clean and shape the contact surface of the vehicle body.
1. Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.