Sienna FWD V6-3.3L (3MZ-FE) (2006)
HINT: Leave as much of the adhesive on the vehicle body as possible.
2. Clean the contact surface of the vehicle body with a piece of shop rag saturated with cleaner.
HINT: Even if all the adhesive has been removed, clean the vehicle body.
b. Position the glass.
1. Using a suction cup, place the glass in the correct position.
2. Check that the whole contact surface of the glass rim is perfectly even.
3. Place reference marks between the glass and vehicle body.
NOTE: Check that the stoppers are attached to the vehicle body correctly.
HINT: When reusing the glass, check and correct the reference mark positions.
4. Remove the glass.
c. Using a brush, coat the exposed part of the vehicle body with Primer M.
NOTE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not coat the adhesive with Primer M.
-
Do not keep any of the opened Primer M for later use.