T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
15. Remove starter wire bracket and No.1 timing belt cover.
(a) Remove the 2 bolts and starter wire bracket.
(b) Remove the 4 bolts and timing belt cover.
16. Remove timing belt guide.
17. Set No.1 cylinder at TDC/Compression.
(a) Temporarily install the crankshaft pulley bolt to the crankshaft.
(b) Turn the crankshaft, and align the timing marks of the crankshaft timing pulley and oil pump body.
NOTICE: Always turn the crankshaft clockwise.
(c) Check that the timing marks of the camshaft timing pulleys and No.3 timing belt cover are aligned.
If not, turn the crankshaft pulley 1 revolution (360°).
(d) Remove the crankshaft pulley bolt.
18. If reusing timing belt check installation marks on timing belt.
Check that there are 3 installation marks and front mark on the timing belt.
If the installation and front marks have disappeared, before removing the timing belt, place 3 new installation marks on the timing belt to match the
timing marks of the timing pulleys, and place a new front mark on the timing belt.
19. Remove timing belt tensioner.
Alternately loosen the 2 bolts and remove them, then remove the belt tensioner and dust boot.