Venza FWD L4-2.7L (1AR-FE) (2009)
(h) Skid control ECU (Brake Actuator) / Techstream Display "ABS/VSC/TRAC"
HINT: DTC communication uses the CAN communication system.
(i) Steering Angle Sensor / Techstream Display "Steering Angle Sensor"
HINT: The steering angle sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(j) Yaw Rate Sensor / Techstream Display "Yaw Rate / Deceleration Sensor"
HINT: The yaw rate and acceleration sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(k) 4WD Control ECU / Techstream Display "Four Wheel Drive Control"
HINT: DTC communication uses the CAN communication system.
(l) Certification ECU / Techstream Display "Smart Access/ Smart Key/ Wireless Tuner"
HINT: DTC communication uses the CAN communication system.
(m)Power Management Control ECU / Techstream Display "Electric Power Control"
HINT:
-
DTC communication uses the CAN communication system.
-
"Electric Power Control" output DTC is communication error in CAN No. 1 bus.
(n) Power Management Control ECU / Techstream Display "Power Management1"
HINT:
-
DTC communication uses the CAN communication system.
-
"Power Management1" output DTC is communication error in CAN No. 2 bus.
(o) Power Management Control ECU / Techstream Display "Power Management2"