Con-rod Bearing, Remove and Install
Remove
Remove lower part of oil pan – see operation "Oil Pan,
Lower Part, Remove and Install".
Remove upper part of oil pan – see operation "Oil Pan
– Upper Part, Remove and Install".
Mark order of con-rod bearing caps (1) – bead (2) of
con-rod bearing caps points to transmission side. Remove con-rod
bearing cap from con-rod. Press con-rod bearing shell out of
con-rod and con-rod bearing cap.
|
|
Clean
Clean con-rod bearing journal and con-rod bearing cap.
Inspect
Check con-rod bearing play – see operation "Con-rod
Bearing Play, Check".
Note:
The upper bearing shells are strengthened and marked "S" (1).
|
|
Install
Insert con-rod bearing shells with engine oil in con-rod and
con-rod bearing caps.
Note order of the con-rod bearing caps – note
identification.
Attach con-rod bearing cap to con-rod with new bolts –
con-rod bearing cap bead points to transmission side –
tightening torque 35 Nm / 26 lbf. ft. + 45° + 15°.
Install upper part of oil pan – see operation "Oil Pan
– Upper Part, Remove and Install".
Install lower part of oil pan – see operation "Lower Part
of Oil Pan, Remove and Install".
|