Replace bracket for outside handle (front door) -
L48 / L35 / 70 / L69
Remove
1. |
Detach front door inner panelling
|
|
2. |
Partly loosen water vapour barrier
• |
Detach 2x front door retainer base inner panelling
|
• |
Loosen water vapour barrier in the area of the hatching
|
|
|
3. |
Disconnect wiring harness plug with vehicles with Open and
Start
• |
Disconnect 2x wiring harness plug
|
|
|
|
4. |
Detach front door panel
• |
Prise off panel (1) with a plastic wedge
|
|
|
|
|
5. |
Remove fixed handle part of front door with lock cylinder
• |
Pull out and hold moveable handle part (I)
|
• |
Turn bolt (II) left until it stops
Note: Moveable handle
part must now be secured in pulled position.
|
• |
Remove fixed handle part with lock cylinder (IV)
|
|
6. |
Detach door handle
• |
Pull back moveable handle part (III) to remove
Note: Disconnect 2x
wiring harness plugs with vehicles with Open and Start
|
|
|
7. |
Bracket for door outer handle, Detach
|
|
|
Install
8. |
Bracket for door outer handle, Attach
|
9. |
Refit door handle
• |
Fit moveable handle part into door panel
|
|
10. |
Install front door fixed handle part with lock cylinder
• |
Install fixed handle part with lock cylinder
|
• |
Turn bolt right until it stops
Note: Hold moveable
handle part in place while turning bolt.
|
|
11. |
Attach front door panel
|
12. |
Connect wiring harness plug with vehicles with Open and
Start
• |
Connect 2x wiring harness plugs
|
|
13. |
Attach water vapour barrier
• |
Attach 2x front door retainer base inner panelling
|
|
14. |
Attach front door inner panelling
|
|