|
Adjust folding roof rear window - L67
Important:
Operation to be carried out only by certified service
operators.
 Adjust
|
| 2. |
Measure rear window gap and height offset
| • |
Check gaps
| – |
Offset on the rear window to the C-pillar inner right and left
0 +/- 1.0 mm (IV)
|
| – |
Height offset on the rear window to folding roof center 1.0 +/-
1.0 mm (I)
|
| – |
Gap between rear window and C-pillar inner right and left 7.5
+/- 1.5 mm (III)
|
| – |
Gap between rear window and folding roof center 7.5 +/- 1.0 mm
(V)
|
| – |
Gap between rear window and luggage compartment lid 10 +/- 1.4
mm (II)
|
|
|
|
| 3. |
Adjust rear window if needed
|
| 4. |
Half open folding top
Note: Align folding
roof within seven minutes, as it otherwise must be mechanically
closed.
|
|
| 5. |
Detach rear window panelling
| • |
Unclip 8x clips (arrows)
|
|
|
|
| 6. |
Align rear window
| • |
Adjust rear window - both sides
| – |
Loosen 4x bolts (2) on Cinematic console
|
| – |
Correct offset and gap to folding roof center
|
|
| • |
Tighten 4x bolts (2) to Cinematic console
|
|
| 7. |
Align rear window
| • |
Adjust rear window - both sides
| – |
Loosen 6x bolts (1) on rear window console
|
| – |
Adjust gap to C-pillar left and right
|
|
| • |
Tighten 6x bolts (1) on rear window console
|
|
|
| 8. |
Detach rear window panelling
|
| 10. |
Measure rear window gap and offset
| • |
Check gaps
| – |
Offset on the rear window to the C-pillar inner right and left
0 +/- 1.0 mm
|
| – |
Offset on the rear window to folding roof center 1.0 +/- 1.0
mm
|
| – |
Gap between rear window and C-pillar inner right and left 7.5
+/- 1.5 mm
|
| – |
Gap between rear window and folding roof center 7.5 +/- 1.0
mm
|
| – |
Gap between rear window and luggage compartment lid 10 +/- 1.4
mm
|
|
|
| 12. |
Return front seat to original position
|
|
