Replace luggage compartment lid hinges (screwed
in) L67 - left side
Important:
Operation to be carried out only by certified service
operators.
Remove
1. |
Detach luggage compartment panelling, left side
|
2. |
Detach luggage compartment lid gas lifter spring
|
3. |
Detach third breaklight
|
4. |
Remove luggage compartment lid
|
5. |
Emergency release Cinematic and place on upper rear
Note: Loosen wiring
harness on Cinematic.
|
|
6. |
Detach Cinematic (left) wiring harness (1)
• |
Detach 11x cable harness clamps (2)
|
• |
Disconnect wiring harness plug.
|
• |
Detach 2x cable ties (3)
|
|
|
|
7. |
Detach cylinder rear lid (1)
• |
Detach fastening clamp (2)
|
• |
Detach Bowden cable (4)
|
• |
Remove rear cover cylinder.
Note: Check for damage
to hydraulic lines (arrows).
|
|
|
8. |
Detach steel folding roof support (1)
• |
Unscrew 3x bolt (arrows)
|
|
|
|
|
9. |
Detach Cinematic (1)
Note: Mark installation
position.
• |
Unscrew 3x bolt (arrows)
|
• |
Detach Bowden cable (2)
– |
Remove Bowden cable from guide
|
|
|
|
Install
10. |
Attach Cinematic
Note: Observe the
installation position.
• |
Attach Bowden cable
– |
Insert Bowden cable into guide
|
|
|
11. |
Attach steel folding roof support
|
12. |
Attach cylinder rear lid
|
13. |
Attach Cinematic (left) wiring harness
• |
Connect wiring harness plug
|
|
15. |
Install luggage compartment lid
|
16. |
Attach third breaklight
|
17. |
Attach luggage compartment panelling, left side
|
|