vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-005 Front Passenger Outside Mirror Heating Circuit > < C-003 Passenger Side Mirror Circuit

Astra H

C-004 - Driver Outside Mirror Heating Circuit

Test

Work Order Description

Nominal Value
T001

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Vehicle without REC (Rear Electronic Module)
Yes: No:
T002

Check: Short to Voltage/Ground/Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    M11D Mirror Unit - Driver Door
  • Ignition ON
  • Measure voltage between the following terminals:
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T003

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Anti-Theft Warning with Central Door Locking
Yes: No:
T004

Check: Short to Ground/Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    X125 Underhood Electronic Module
    (Wiring Harness Connector XE1 )
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

greater than 500 kOhm
Resistance Measurement Current Value: kOhm
Yes: No:
T005

Check: Interruption of Signal Circuit
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 46 (XE1)

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T006

Check: Circuit Interruption of Ground Circuit
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 9
    &
    Ground

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T007

Check: Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    X125 Underhood Electronic Module
    (Wiring Harness Connector XE1 )
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 46 (XE1)

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T008

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Anti-Theft Warning with Central Door Locking
Yes: No:
T009

Check: Short to Voltage of Signal Circuit
  • Ignition OFF
  • Remove following component:
    K17_X125 Relay - Back Window, Heated
  • Ignition ON
  • Measure voltage between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T010

Check: Short to Voltage/Ground/Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    M11D Mirror Unit - Driver Door
  • Ignition ON
  • Measure voltage between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T011

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Anti-Theft Warning with Central Door Locking
Yes: No:
T012

Check: Short to Ground/Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    X131 Rear Electronic Module
    (Wiring Harness Connector XR4 )
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

greater than 500 kOhm
Resistance Measurement Current Value: kOhm
Yes: No:
T013

Check: Interruption of Signal Circuit
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 11 (XR4)

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T014

Check: Circuit Interruption of Ground Circuit
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 9
    &
    Ground

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T015

Check: Interruption of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    X131 Rear Electronic Module
    (Wiring Harness Connector XR4 )
  • Measure resistance between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 11 (XR4)

less than 5 Ohm
Resistance Measurement Current Value: Ohm
Yes: No:
T016

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Anti-Theft Warning with Central Door Locking
Yes: No:
T017

Check: Short to Voltage of Signal Circuit
  • Ignition OFF
  • Remove following component:
    K3_X131 Relay - Heated Back Window
  • Ignition ON
  • Measure voltage between the following terminals:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:


Result

Cause Of Fault
E001 Result: Defective Component
  • Defective component:
    M11D.3 Heating - Outside Mirror, Driver Door
    or
    X125 Underhood Electronic Module

Note:

The replacement of the components must be done in the listed order.

The system must be checked for proper operation after every replacement.

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E002 Result: Interruption
  • Circuit interruption between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 9
    &
    Ground
E003 Result: Interruption
  • Circuit interruption between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 46 (XE1)
E004 Result: Short to Ground
  • Short circuit to ground between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    M11P.3 Heating - Outside Mirror, Passenger Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 46 (XE1)
E005 Result: Short to Voltage
  • Short circuit to voltage between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    M11P.3 Heating - Outside Mirror, Passenger Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    A1_X125 Control Unit - Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 46 (XE1)

or

  • Defective component:
    A1_X125 Control Unit - Underhood Electronic Module

Note:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E006 Result: Defective Component
  • Defective component:
    K17_X125 Relay - Back Window, Heated
    or
    A1_X125 Control Unit - Underhood Electronic Module

Note:

The replacement of the components must be done in the listed order.

The system must be checked for proper operation after every replacement.
E007 Result: Defective Component
  • Defective component:
    M11D.3 Heating - Outside Mirror, Driver Door
    or
    X131 Rear Electronic Module

Note:

The replacement of the components must be done in the listed order.

The system must be checked for proper operation after every replacement.

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E008 Result: Interruption
  • Circuit interruption between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 9
    &
    Ground
E009 Result: Interruption
  • Circuit interruption between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 11 (XR4)
E010 Result: Short to Ground
  • Short circuit to ground between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    M11P.3 Heating - Outside Mirror, Passenger Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 11 (XR4)
E011 Result: Short to Voltage
  • Short circuit to voltage between:
    M11D.3 Heating - Outside Mirror, Driver Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    M11P.3 Heating - Outside Mirror, Passenger Door
    Wiring harness connector (wiring harness side) terminal 8
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 11 (XR4)

or

  • Defective component:
    X131 Rear Electronic Module

Note:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E012 Result: Defective Component
  • Defective component:
    K3_X131 Relay - Heated Back Window
    or
    X131 Rear Electronic Module

Note:

The replacement of the components must be done in the listed order.

The system must be checked for proper operation after every replacement.





C-005 Front Passenger Outside Mirror Heating Circuit > < C-003 Passenger Side Mirror Circuit