|
Replace protective trim strip for rear door -
L08
| 1. |
Remove right and left tail lights 
|
| 2. |
Lift vehicle half way up
|
Important: Danger of damage!
Unlock rear panelling carefully from rear quarter panel!
|
| 3. |
Loosen rear panelling, side right and left
| • |
Unscrew 2x screws right (2)
|
| • |
Press rear panelling in the area of the rear quarter panel
upwards and pull outwards, side
|
| • |
Unclip rear panelling from outer guide rail right 4x
|
| • |
Unscrew 2x screws left (4)
|
| • |
Press rear panelling in the area of the rear quarter panel
upwards and pull outwards, side
|
| • |
Unclip rear panelling from left outer guide rail right 4x
|
|
| 4. |
Loosen middle rear panelling
|
| 5. |
Remove number plate lighting (arrow)
| • |
Remove number plate lighting
|
| • |
Disconnect 2x wiring harness plug
|
|
|
|
| 6. |
Detach rear panelling (1)
Note: 2nd mechanic
required!
| • |
Unlock 3x bracket on rear right guide rail (2)
|
| • |
Unlock 2x brackets on middle guide rail (3)
|
| • |
Unlock 3x bracket on rear left guide rail (4)
|
|
|
|
| 7. |
Remove trim strip
| • |
Remove crash absorber (1)
|
|
|
|
Install
| 8. |
With vehicles with Parkpilot sensor: Attach Parkpilot sensor
bracket
|
| 10. |
Attach rear panelling
Note: 2nd mechanic
required!
| • |
Lock 3x guides to upper rear left guide rail
|
| • |
Lock 2x guides to middle guide rail
|
| • |
Lock 3x guides to upper rear right guide rail
|
| • |
Clip in 4x rear panelling to outer left guide rail
|
| • |
Clip in 4x rear panelling to outer right guide rail
|
|
| 11. |
Attach middle rear panelling
|
| 12. |
Install number plate lighting
| • |
Connect 2x wiring harness plugs
|
| • |
Position number plate lighting
|
|
| 13. |
Attach side rear panelling left and right
| • |
Tighten 2x screws left 2.5 Nm
|
|
| 14. |
Attach side rear panelling
| • |
Tighten 2x bolts right 2.5 Nm
|
|
| 15. |
Lower vehicle half way down
|
| 16. |
Install right and tail lights
|
|
