vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-099 Fuse FR30 Circuit > < C-097 Fuse FR27 Circuit

Astra H

C-098 - Fuse FR29 Circuit

Test

Work Order Description

Nominal Value
T001

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Reconnect all disconnected components
  • All consumers turned off
  • Insert new fuse FR29 and then check the fuse for proper operation.

Test okay?
Yes: No:
T002

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Front Cigarette Lighter
Yes: No:
T003

Check: Short to Ground of Voltage Supply Circuit
  • Disconnect wiring harness connector from:
    R1 Cigarette Lighter
  • Insert new fuse FR29 and then check the fuse for proper operation.

Test okay?
Yes: No:


Result

Cause Of Fault
E001 Result: System Overload
  • A temporary current overload in the system behind fuse FR29 has occurred

Note:

In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.

These circuits should be checked additionally for short to ground.
E002 Result: Defective Component
  • If the nominal value is reached during one of the measurements, the component/control unit that has been disconnected immediately before that measurement is defective.

Note:

If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.

These circuits should be checked additionally for short to ground.
E003 Result: Short to Ground
  • Short circuit to ground between:
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 3 (XR3)
    &
    R1 Cigarette Lighter
    Wiring harness connector (wiring harness side) terminal 2

or

  • Defective component:
    X131 Rear Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E004 Result: Short to Ground
  • Short circuit to ground between:
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 3 (XR3)
    &
    X112FR Accessory Socket, Front
    Wiring harness connector (wiring harness side) terminal 2

or

  • Defective component:
    X131 Rear Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.





C-099 Fuse FR30 Circuit > < C-097 Fuse FR27 Circuit