Combined Tail Light / Lamp Holder (Circuit Board),
Replace L08
Remove
1. |
Remove combined tail light
• |
Take out combined tail light
|
• |
Disconnect wiring harness plug (1)
|
|
|
|
3. |
Transfer the necessary lamp unit
|
|
|
Install
4. |
Install bulb holder
• |
Clip in 4x clip
Note: Retaining clips
must engage audibly.
|
|
Important: Before fitting the
tail light, check that the tail light gasket is seated
correctly.
|
5. |
Attach gasket (2)
Note: The gasket (1)
with the flat side must not be confused with the gasket (3).
|
|
|
6. |
Install combined tail light
• |
Connect wiring harness plug
|
• |
Insert combined tail light
|
|
|