Vauxhall Workshop Service and Repair Manuals > Astra J > Transmission/Transaxle | Clutch | Repair Instructions | Clutch Actuator Cylinder Front Pipe Replacement - LHD

Clutch Actuator Cylinder Front Pipe Replacement (LHD - MZ0,MZ4,MR5,MF3)

1.	Remove battery tray. Refer to Battery Tray Replacement .

2.	Remove radiator surge tank clip (2).

3.	Remove radiator surge tank (1) and lay aside.

4.	Place basin underneath.

5.	Clip clutch actuator cylinder front pipe (2) out of 2 retainers.

6.	Open retaining clip (1).

7.	Disconnect clutch actuator cylinder front pipe from clutch actuator cylinder pipe elbow.

8.	Remove 2 brake pressure modulator valve bracket bolts (1).

9.	Open retaining clip (arrow).

10.	Disconnect clutch actuator cylinder front pipe (1) from clutch master cylinder.

Note: For removal of clutch actuator cylinder front pipe lift brake pressure modulator valve bracket carefully.

11.	Remove clutch actuator cylinder front pipe.

Note: For installation of clutch actuator cylinder front pipe lift brake pressure modulator valve bracket carefully.

1.	Install clutch actuator cylinder front pipe.

2.	Connect clutch actuator cylinder front pipe (1) to clutch master cylinder.

3.	Close retaining clip (arrow).

4.	Connect clutch actuator cylinder front pipe (2) to clutch actuator cylinder pipe elbow.

5.	Close retaining clip (1).

6.	Clip clutch actuator cylinder front pipe into 2 retainers.

Caution: Refer to Fastener Caution .

7.	Install 2 brake pressure modulator valve bracket bolts (1) and tighten to 20 N·m (15 lb ft) .

8.	Install radiator surge tank (1).

9.	Install radiator surge tank clip (2).

10.	Bleed hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding .

11.	Install battery tray. Refer to Battery Tray Replacement .