Remove retaining clip and washer from lever actuation on transmission. Remove cable from selector lever actuation (illus. I). Unbolt fastening nuts from bracket for cable on transmission. Remove selector lever cover from shift tunnel - see corresponding operation in this group. Remove centre console - see corresponding operation in group C. Release cable from selector lever (1) and console (2). Unscrew retaining nut (2) from thread. Pull cable into engine compartment through bulkhead.
 Install, Connect Screw on cable at actuation lever and at console and selector lever - 6 Nm / 4 lbf. ft. Ensure that rubber sleeve is correctly seated in bulkhead.
 Adjust Adjust selector lever - see operation "Selector Actuation Bowden Cable, Adjust". | 
Remove, Disconnect 