Drive Gear (Driven), Remove and Install (Transmission Installed) (F 10/F 15)
 Remove, Disconnect Remove differential - see operation "Differential, Overhaul". Clamp differential with KM-520 in vice. Unscrew drive gear from differential housing and knock off with brass drift.
 Install, Connect Heat drive gear to approx. 80 ° C, position on differential housing and bolt on. Install differential in transmission - observe "Adjustment Regulations for Tapered Roller Bearing (Differential)". Bolt cover for differential to transmission - tightening torque 18 Nm / 13 lbf. ft. Top up transmission fluid - see operation "Transmission Fluid Level, Check".
 Torque - Angle Method F 10: Drive gear to differential housing - 40 Nm / 30 lbf. ft. + 30 ° + 15 ° . F 15: Drive gear to differential housing - 70 Nm / 52 lbf. ft. + 30 ° to 45 ° .
|
