vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Cooling Pump, Remove And Install (Z 17 DTH, With Air Conditioning, LHD) > < Remove and install oil pump (Z 10 XE, Z 10 XEP, with air conditioning, LHD)

Corsa C

Coolant Pump, Replace

  Remove

1.   Open bonnet
Important:   On vehicles as of model year 04 with ESP - every time the battery is disconnected, the steering angle sensor loses its basic setting. It must be recalibrated.
2.   Disconnect battery
•   Detach ground cable
3.   Drain coolant
•   Place collecting basin underneath.
•   Open drain bolt
Object Number: 2411059 Size: DEFAULT


4.   Raise vehicle
5.   Remove lower engine compartment cover / splash protection
6.   Remove ribbed V-belt (1)
•   Tension ribbed V-belt tensioner in direction of arrow
•   Fit KM-6130 (2)
Note:   Mark running direction.
Object Number: 2406286 Size: DEFAULT


7.   Remove coolant pump (1)
•   Unscrew 4 nuts
Object Number: 2406320 Size: DEFAULT


8.   Cleaning work

  Install

9.   Install coolant pump
•   Replace seal ring
•   Tighten 4 nuts 9 Nm
10.   Install ribbed V-belt
Note:   Note running direction.
•   Release ribbed V-belt tensioner
– Remove KM-6130
11.   Install lower engine compartment cover / splash protection
12.   Lower vehicle
13.   Top up coolant
14.   Connect battery
15.   Program volatile memory
16.   Close bonnet

Cooling Pump, Remove And Install (Z 17 DTH, With Air Conditioning, LHD) > < Remove and install oil pump (Z 10 XE, Z 10 XEP, with air conditioning, LHD)