|
Shift Guide, Dismantle and Assemble (F13/F17/F17
new/ F17+)
 Remove
| 2. |
Unclip shift guide rod (1)
|
| 3. |
Unclip adjuster (2) by pivoting (arrow)
|
| 4. |
Unclip intermediate lever (3) by pivoting (arrow)
|
| 5. |
Detach sealing discs (4) and (5) from adjuster and intermediate
lever
|
| 6. |
Remove retaining rings (6) and (7) from adjuster and
intermediate lever
|
|
|
| 7. |
Remove bearing shell (1) from adjuster and remove intermediate
lever
| • |
Clamp adjuster or intermediate lever in a vice and push out
bearing shell
|
|
| 8. |
Detach protective cap (2) from guide lever
|
| 9. |
Remove guide lever bearing bushings (3) and (4) with
screwdriver
|
|
|
Install
| 11. |
Check all parts for wear and replace if necessary
|
| 12. |
Grease bushings and bearing points with silicone grease
|
| 13. |
Press guide lever bushings (1) and (2) into guide lever
|
| 14. |
Attach guide lever (3) to shift rocker arm (4)
| • |
Ensure that it engages completely
|
| • |
Secure shift rocker arm with protective cap (5)
|
|
|
|
| 15. |
Push intermediate lever bearing shell (1) and adjuster bearing
shell (2) onto shift rocker arm (arrows)
|
| 16. |
Push intermediate lever (3) and adjuster onto guide lever
| • |
Ensure that it engages completely
|
| • |
Pay attention to correct installation position
|
| • |
Secure intermediate lever with retaining ring
|
|
| 17. |
Attach sealing discs (4) and (6) to adjuster and intermediate
lever
|
| 18. |
Attach shift guide rod (5) to adjuster and intermediate
lever
|
| 20. |
Transmission Shift Linkage, Adjust 
|
|
|
|
