|
Differential gear cover gasket, replace (F13/F13
MTA/F17/F17 new/F17+/F17+ MTA)
 Remove
| 1. |
Remove lower engine cover
Note: If present.
|
| 2. |
Release shift guide (3) upwards from bracket (1)
| • |
Detach retaining clamp (2).
Note: Upper bracket
bolt - rear torque support (4) is now accessible.
|
|
| 3. |
Detach rear torque support bracket from transmission
|
| 4. |
Swivel rear torque support away from transmission
| • |
Undo rear torque support bolt (5) from front axle body
Note: Differential gear
cover bolts are now accessible.
Note: For a better
illustration, the exhaust system is removed.
|
|
|
|
| 5. |
Detach catch hooks (1)
|
|
|
| 6. |
Place collecting pan underneath.
|
| 7. |
Remove differential gear cover
| • |
10 bolts
Note: Release
differential gear cover by tapping gently with a rubber mallet if
necessary. Transmission fluid runs out.
|
|
| 8. |
Remove gasket for differential gear cover
|
|
|
Install
| 9. |
Clean sealing surfaces
|
| 10. |
Fit differential gear cover to transmission with new gasket
| • |
Stick gasket to differential gear cover with grease
|
| • |
Screw down the cover
| – |
Sheet metal version 30 Nm
|
|
|
| 11. |
Attach rear torque support bracket to transmission with new
bolts
| • |
Tighten bolts 80 Nm + 45° –
60°
|
|
| 12. |
Attach rear torque support to front axle unit
|
| 13. |
Attach shift guide to bracket
| • |
Secure shift guide with securing clamps
|
|
| 14. |
Attach catch hooks
| • |
Tighten catch hooks 18 Nm
|
|
| 15. |
Install lower engine cover
Note: If present.
|
| 16. |
Check transmission fluid level and correct if necessary
|
|
