Crankshaft Pulse Pick-up, Remove and Install (X 25 XE)
Remove, Disconnect
Disconnect covers (3 units) above air deflector panel.
Disconnect wiring harness plug (1) of crankshaft pulse pick-up.
Lay crankshaft pulse pick-up out of the way - note cable routing.
Detach crankshaft pulse pick-up (2) from cylinder block and remove.
Install, Connect
Attach crankshaft pulse pick-up to cylinder block with new seal ring - tightening torque 8 Nm / 6 lbf. ft.
Note cable routing. Fasten cable (1) with cable straps (2) and clips (3).
Connect wiring harness plug of crankshaft pulse pick-up.
Connect covers (3 units) above air deflector panel.