Note sequence of con-rod bearing caps. Attach con-rod bearing caps to con-rod with new fastening bolts - beads (1) on con-rod bearing caps point towards flywheel side - tightening torque 35 Nm / 26 lbf. ft. + 45 ° + 15 ° . Apply a bead of adhesive sealing compound (black) to joints of oil pump and rear crankshaft bearing cap. Attach crankshaft bearing bridge to cylinder block - 20 Nm / 15 lbf. ft. For X 20 XEV, C 22 SEL: install differential (balancer shaft unit) - see operation "Differential (Balancer Shaft Unit), Remove and Install (X 20 XEV, C 22 SEL)". Attach oil baffle plate to crankshaft bearing bridge - tightening torque 20 Nm / 15 lbf. ft. Attach oil intake pipe with new gasket to oil pump - tightening torque 8 Nm / 6 lbf. ft. Attach oil intake pipe to crankshaft bearing bridge - tightening torque 20 Nm / 15 lbf. ft. Install upper part of oil pan - see operation "Oil Pan - Upper Part, Remove and Install". Install cylinder head - see operation "Cylinder Head, Remove and Install". |