Engine damping blocks may be replace in pairs only.
Remove, Disconnect
Disconnect torque support from both torque support brackets.
In I: Remove lateral engine compartment cover.
Remove front axle body - see operation "Front Axle Body, Remove and Install" in group "E". Lower complete drive unit using Engine Bridge MKM-883-1 until fastening nut (1) is accessible.
Disconnect engine damping block from engine damping block bracket and from transmission bracket - note installation position.
Install, Connect
Connect engine damping block to engine damping block bracket and to transmission bracket - note installation position - tightening torque 45 Nm / 33.2 lbf. ft.
Install front axle body - see operation "Front Axle Body, Remove and Install" in group "E".
In I: Install lateral engine compartment cover.
Connect torque support to both torque support brackets - tightening torque 60 Nm / 44.2 lbf. ft.
Remove, Disconnect 
Install, Connect