Vauxhall Workshop Service and Repair Manuals

Selector Lever Position Switch, Remove and Install  

  Remove, Disconnect   

Remove battery - to do this, remove small relay box. If present: remove reservoir for hydraulic system from battery box (2 bolts) and set aside. Release selector lever position switch wiring harness (10) and separate.   With AF 20/22: remove fluid filler tube - see operation "Fluid Filler Tube and/or Gasket, Replace".   With all transmissions: press selector actuation control cable (1) from actuating lever for selector lever shaft. Actuating lever (5) from selector lever shaft (8) - to do this, remove nut (4). Bend up retaining plate (9), remove nut (3). Selector lever position switch from transmission (2 and 6). Remove retaining plate (7) and selector lever position switch upwards.

 

Adjust position of selector lever position switch relative to transmission.     Install, Connect    Set selector lever position switch to selector lever shaft (3) - attach nut with locking plate to selector lever shaft. Attach screws (2, 4) with holding plate for transmission wiring harness. Selector lever shaft with pliers into neutral - turn right until stop and then switch back 2 notches (P, R, N - see F 1540).     Adjust    Adjust selector lever position switch - see operation "Selector Lever Position Switch, Adjust".     Install, Connect    Attach operation lever with nut to selector lever shaft. Lock wiring harness plug of selector lever position switch. Press actuation cable selector onto operation lever - has to lock audibly. Install fluid filler tube - see operation "Fluid Filler Tube and/or Seal Ring, Replace". Reservoir for hydraulic system at battery box. Install battery - plug in small relay box.     Tighten (Torque)    Nut at selector lever shaft - 8 Nm / 6 lbf. ft.   Selector lever shaft - 16 Nm / 12 lbf. ft.