Vauxhall Workshop Service and Repair Manuals

V-belt for Power Steering Pump, Remove and Install (X 17 DT)  

  Remove, Disconnect   

Remove air cleaner housing - see operation "Air Cleaner Housing, Remove and Install" in group "J".   Release compressor V-belt by means of V-belt tension roller - for this purpose release bolt (1) and turn bolt (2) clockwise. Set aside V-belt.   Loosen power steering pump fastening bolts - see operation "Power Steering Pump, Remove and Install (X 17 DT)".   Release tensioning screw (3) and release power steering pump V-belt tension in direction of arrow and remove.     Install, Connect    Position and tension power steering pump V-belt. Tighten tension bolt (3) - tightening torque 40 Nm / 30 lbf. ft.   Tighten power steering pump fastening bolts - see operation "Power Steering Pump, Remove and Install (X 17 DT)".

  Install, Connect   

Position compressor V-belt and tension by means of V-belt tension roller.  

Tighten fastening bolt for V-belt tension roller.  

Install air cleaner housing - see operation "Air Cleaner Housing, Remove and Install" in group "J".  

  Inspect   

Check V-belt tension with KM-128-A (1).   Test values:   250 - 300 N   (Run-in V-belt)     450 N   (new V-belt)