Fluid Reservoir, Remove and Install (X 16 SZR, X 16 XEL, Y 16 XE, X 18 XE1, Z 16 XE, Z 18 XE, Z 18 XEL)
 Remove, Disconnect Remove power steering pump - see operation "Power Steering Pump, Remove and Install (Vehicles with 4-Cylinder Petrol Engine, except Z 22 SE)". Remove upper and lower retaining clips:
|
I |
Insert suitable screwdriver into clamp plate. |
|
II |
Raise clamp plate by twisting screwdriver. |
|
III. |
Press retaining clip forward by advancing screwdriver (in direction of arrow). |
|
IV. |
Drive off retaining clip with suitable drift from power steering pump/fluid reservoir. |
Remove fluid reservoir from power steering pump. | 
|
 Install, Connect Press fluid reservoir with new seal ring (1) onto power steering pump. Attach new upper and lower retaining clips and drive on with drift until clamp plate engages. Install power steering pump - see operation "Power Steering Pump, Remove and Install (Vehicles with 4-Cylinder Petrol Engine)". | 
|
|
