Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Pull center cover -1- forward out of latch and remove from instrument panel (arrow).
-
Remove screws -1-.
-
Lift left plenum panel cover -1- and remove from clips at front and rear edge.
-
Pull cover -1- toward center of vehicle and out of retainer in A-pillar to remove.
-
Lift right plenum panel cover -2- and remove from clips at front and rear edge.
-
Pull cover -2- toward center of vehicle and out of retainer in A-pillar to remove.
-
Remove mounting bolts from left closeout panel -3- and right closeout panel -4- and pull panels upward out of plenum to remove.
-
Remove both A-pillar trim pieces.
-
Remove screws -6- to allow removal of center defroster duct -5- and end pieces -7-.
-
Remove boot from defroster duct to center air distribution duct -arrow-.
-
Remove center defroster duct.
The TCM is located in the plenum chamber center right.
-
Inspect TCM ground (GND) connection (must not be loose or corroded and terminal must be crimped on wire correctly).
Overlay harness, installing