volkswagen Workshop Repair Guides

Volkswagen Beetle 19L Diesel Turbo Workshop Manuals

A/T Controls - MIL ON/DTC 00281 Stored in Memory|Page 5196 > < A/T Controls - MIL ON/DTC 00281 Stored in Memory|Page 5194
Page 3
background image

-

Connect overlay harness to Road Speed Sender -G68-.

-

Route overlay harness along existing harness to plenum opening. White dotted line indicates general routing.

-

Lightly pull on engine/ transmission harness -arrow- at plenum to loosen harness plenum grommet.

-

Route overlay harness along side of grommet into plenum area.

-

Route overlay harness in plenum along existing harness to Transmission Control Module (TCM) connector.

-

Disconnect multi-pin connector from TCM.

-

Cut tie wrap at end of connector and remove cover from connector by depressing tab with small screwdriver while pushing cover in direction of
-arrow-.

-

Obtain appropriate pin removal tool from VAS 1978 wire harness repair kit.

-

Locate cavity 65 of TCM connector (yellow wire) and remove terminal.

-

Insert the yellow wire of overlay harness into cavity 65.

-

Locate cavity 20 of TCM connector (white wire) and remove terminal.

-

Insert the white wire of overlay harness into cavity 20.

-

Locate cavity 43 of TCM connector (black wire) and remove terminal.

-

Insert the black wire of overlay harness into cavity 43.

-

Cut 3 wires (previously removed) as close as possible to the taped section of harness.

-

Install cover using new tie wrap.

-

Install multi-pin connector to TCM.

-

Tie wrap overlay harness to existing harness in plenum and engine compartment as necessary to ensure routing and prevent rattles.

-

Install defroster duct, boot and all plenum covers in reverse order of removal.

-

Install engine wiring harness covers.

-

Install air cleaner housing (see Repair Manual Group 24).

-

Install battery and battery tray (see Repair Manual Group 27).

WARNING:  

Ensure that there is no person inside the vehicle when connecting battery ground strap.

-

Connect battery ground (GND) strap.

-

Connect VAS 5051/5052 Scan Tool.

-

Check all systems for stored DTC's.

-

Erase any stored DTC's.

-

After connecting battery, check vehicle equipment (radio code, clock, electric windows) as per Repair Manual and/or Owner's Manual.

-

Program radio station presets.

A/T Controls - MIL ON/DTC 00281 Stored in Memory|Page 5196 > < A/T Controls - MIL ON/DTC 00281 Stored in Memory|Page 5194