Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1173004.png)
-
Remove the brake caliper and secure it with wire so that the weight of the brake caliper does not burden or damage the brake hose.
-
Remove the brake pads and anti-rattle springs - arrows -.
Cleaning
CAUTION!
Do not use compressed air to blow on the brake system components, the dust produced is harmful to health!
-
Contact surfaces between the brake pads and brake carrier must be cleaned, removing any corrosion.
-
Clean the brake caliper.
Use only appropriate solvents for cleaning brake caliper.
Installing
Before pressing the piston into the cylinder bore, some brake fluid must be extracted from the brake fluid reservoir. Otherwise, especially if
the reservoir has been topped off, fluid will overflow and cause damage.
-
Press the piston into the bore using the resetting & extracting tool ( T 10165 ) and (1065/1). Do not damage the protective caps.
