Volkswagen Workshop Service and Repair Manuals

• Wishbone
• Self-locking hexagon nut, 120 Nm
• Hexagon bolt
  M 12 x 1.5 x 100
• Handbrake cable
• ◆ Adjusting handbrake
• Rubber mounting
• ◆ Pulling out =>Fig. 1
• ◆ Pulling in =>Fig. 2
• Wishbone
• Hexagon socket head bolt, 10 Nm
• Speed sensor
• Brake drum
• ◆ Repair instructions

• Cross-head screw
• Fitted washer
• Self-locking hexagon nut
• ◆ Tighten first to 90 Nm and then turn45°further (1/8 turn).
• ◆ Before fitting nut to outer joint remove any paint remains and/or corrosion from threads.
• ◆ To tighten we recommend angle measuring wrench V.A.G 1756
• Wheel bearings
• ◆ Servicing
• Brake lining
• ◆ Repair instructions
• Self-locking hexagon nut, 65 Nm

• Shock absorber
• ◆ Removing and installing , Fig. 1
• Hexagon bolt
• Drive shaft
• ◆ Servicing
• Multi-point socket head bolt, 45 Nm
• Plate
• Hexagon bolt
  M 12 x 1.5 x 95
• Inner rubber mounting
• ◆ Pulling out =>Fig. 1
• ◆ Pulling in =>Fig. 2
• ◆ Chamber and track can be corrected by rubber mounting with an eccentric bush =>Fig. 3
• Self-locking hexagon nut, 120 Nm

→ Fig.1    Pulling rubber mounting out of wishbone

• ‒ Before pulling out, cut the shoulder (arrow) off the rubber mounting.

Note:

Grease threads and washer

→ Fig.2    Pulling rubber mounting into wishbone

•     A -    Washer

• ‒ Coat rubber mounting with a lubricant e.g. soft soap.
• ‒ Fit rubber mounting so that the outer mounting shoulder faces outwards. (On the inner mounting inwards).
• ‒ Pull in, so that the mounting shoulder seats on the wishbone.

→ Fig.3    Rubber mounting to correct camber/track

This rubber mounting -A- is equipped with an eccentric bush and therewith the wishbone position can be changed.

This rubber mounting may only be installed in the wishbone inner mounting. The camber and/or track can be changed according to installation position.

Note:

With this mounting the camber or track can be altered up to 18 '.