Golf Mk6
Coolant hose schematic diagram |
1 - | Radiator |
q | Removing and installing → Chapter. |
q | If renewed, refill system with fresh coolant. |
2 - | Coolant circulation pump -V50- |
q | The flow of the coolant in the run-on phase is opposite to the flow shown. |
q | The function can be checked using final control diagnosis → Vehicle diagnostic tester |
3 - | Bypass thermostat |
q | Check → Chapter. |
4 - | Thermostat housing |
q | With thermostat. |
q | Checking thermostat → Vehicle diagnostic tester„Function and component selection“. |
5 - | Coolant pump |
q | Removing and installing. |
6 - | Cylinder head/cylinder block |
q | If renewed, refill system with fresh coolant. |
7 - | Turbocharger |
q | Removing and installing → Chapter. |
8 - | Expansion tank |
Note
When renewing expansion tank and during service operations, ensure that 2 silicate cartridges → Electronic parts catalogue are always in expansion tank. The silicate cartridges must not be removed. |
q | With cap |
q | Test cooling system for leaks using cooling system tester -V.A.G 1274 B- and adapter for cooling system tester -V.A.G 1274/8-. |
9 - | Heat exchanger for heater |
q | If renewed, refill system with fresh coolant. |
10 - | Hose |
q | Only for automatic gearbox. |
11 - | Gearbox oil cooler |
q | Only for automatic gearbox. |
12 - | Bypass thermostat |
q | Only for automatic gearbox. |
q | Check → Chapter. |
13 - | Coolant connecting pipe |
14 - | Engine oil cooler |
15 - | Intake manifold |
q | Removing and installing → Chapter. |
16 - | Hose |
q | Only for additional cooler |
17 - | Additional cooler |
q | Optional equipment. |
18 - | Hose |
q | Only for additional cooler |