Volkswagen Workshop Service and Repair Manuals

Removing and installing engine speed sender Special tools and workshop equipment required

t  Assembly tool -T10118-

t  4 mm socket insert -T10370- Removing Fitting location → Item –  Remove noise insulation → General body repairs, exterior; Rep. gr.66.

–  Clamp off coolant hoses from the engine oil cooler with the hose clips up to 25 mm -3094-. –  Undo the spring clips using -arrow-with the spring clip pliers -VAS 6362-.   Note Collect escaping coolant with drip tray -VAS 6208-. –  Pull coolant hoses off engine oil cooler. –  Remove oil filter bracket with engine oil cooler → Chapter

–  Release and pull off connector on engine with assembly tool -T10118-.

–  Loosen securing bolt -arrow- with socket AF 4 mm -T10370- and remove speed sender. Installing Install in reverse order. In the process, note the following: –  Install oil filter bracket with engine oil cooler. –  Replenish coolant → Chapter.

Specified torques

Component	Specified torque
Engine speed sender -G28-	5 Nm
Oil filter bracket	→ Chapter „Removing and installing engine oil cooler“