Golf Mk6
| Assembly overview: wheel bearing housing, trailing arm (front-wheel drive) |
| 1 - | Bolt |
| q | 50 Nm + 45° further |
| q | Always renew after removing. |
| 2 - | Mounting bracket |
| 3 - | Bolt |
| q | 90 Nm + 90° further |
| q | Always renew after removing. |
| 4 - | Coupling rod |
| q | Connects anti-roll bar to trailing arm and wheel bearing housing |
| 5 - | Bolt |
| q | 90 Nm + 45° further |
| q | Observe tightening sequence → |
| q | Always renew after removing. |
| 6 - | Trailing arm |
| q | Removing and installing → Chapter. |
| q | Repairing → Chapter |
| 7 - | Bolt |
| q | 8 Nm |
| 8 - | Rear right speed sensor -G44-/rear left speed sensor -G46- |
| q | Can be tested in guided fault finding using → Vehicle diagnostic tester |
| q | Before inserting sensor, clean inner surface of hole and coat with lubricating paste -G 000 650-. |
| 9 - | Wheel bearing housing |
| q | Removing and installing → Chapter. |
| 10 - | Bonded rubber bush |
| q | Renewing → Chapter. |
| 11 - | Nut |
| q | 45 Nm |
| q | Always renew after removing. |
| 12 - | Bolt |
| q | 4 Nm |
| 13 - | Brake disc |
| 14 - | Dust cap |
| q | Always renew after removing. |
| q | Pressing off and driving in → Chapter |
| A proper seal can be achieved only by installing a new grease cap. |
| 15 - | Bolt |
| q | 180 Nm + 180° further |
| q | Loosen and tighten with bit XZN 18 -T10162- |
| q | Always renew after removing. |
| 16 - | Wheel hub with wheel bearing |
| q | ABS sensor ring is installed in wheel bearing. |
| q | Removing and installing → Chapter. |
| The wheel bearing and wheel hub are assembled in one housing. |
| This wheel bearing/wheel hub unit is maintenance-free and has zero play. Adjustments and repairs are not possible! |
| 17 - | Bolt |
| q | 12 Nm |
| 18 - | Splash plate |