Volkswagen Workshop Service and Repair Manuals

• Gearbox
• Ball stud, 25 Nm
• ◆ Lubricate with MoS2 grease
• O-ring
• ◆ Always renew
• Input shaft oil seal
• ◆ Renewing
• Guide sleeve
• ◆ Lubricate in area of release bearing with MoS2 grease
• Retaining spring
• ◆ Secure to clutch release lever

• Securing bolt, 20 Nm
• Clutch release lever
• Release bearing
• ◆ Do not wash-out bearing, only wipe
• ◆ Renew noisy bearings
• ◆ Lubricate surfaces which contact release lever with MoS2 grease
• Securing bolt, 20 Nm
• Slave cylinder
• ◆ Removing and installing
  => Page 30-15
• Plunger
• ◆ Grease end of plunger with MoS2 grease

• Assembly bolt
• ◆ Secures the clutch release lever when installing gearbox
  
• ◆ Unscrew after gearbox has been installed

Note:

If the assembly bolt (Item13 ) is not available, an M 8 x 35 bolt can be used.