940 L4-2.3L SOHC VIN 88 B230F (1992)
- Turn handle to right until knob disengages.
- Install gear housing.
- Install cover.
- Install crank.
Note: Always use screws with locking agent on gear housing, or apply locking agent to old screws.
Power sunroof:
- Check that motor is zeroed:
- Run motor rearwards (sunroof opens) to stop position, this takes 4-5 seconds.
- Run motor forwards (sunroof closes) to stop position, this takes 4-5 seconds.
- Mark position where motor stops.
- Run motor forwards to stop position (sunroof to ventilation position).
- Run motor rearwards to stop position (sunroof closes from ventilation position), this takes 1-2 seconds.
- Mark position where motor stops.
- If motor does not stop in same position as earlier, adjust to a point between the two marks, depress the centre button and turn it with a
screwdriver.
Install motor:
- Adjust control mechanisms to neutral positions.
- If this is difficult, move control mechanism forward on one side.
- If it is still not possible to install motor, return control mechanism to neutral position and move other side 1-2 mm forwards.
- A displacement of the control mechanisms 1-2 mm forwards is permissible.
Check function.
Install cover.