940 L4-2.3L SOHC VIN 88 B230F (1992)
-
The cut conduit section should be placed at the lowest point in the cable routing.
-
Use butyl tape to seal the grommet
-
Use existing clamps to clamp up the cables to firewall.
Installation of control module from kit.
A12
Connection and mounting of control module
-
Connect cable harness connector to control module connector.
-
Apply three butyl tape sections on the control module. Install control module on dashboard side section with butyl tape.
A13
Fastening cable harness
-
Arrange cable harness as shown.
-
Fasten the new cable harness using strip clamps in the existing cable harness so that the harness does not contact the shutter shaft on the heater.
Function verification and information
A14
Check airing cycle is working
