940 L4-2.3L SOHC VIN 88 B230F (1992)
Cable connections
Installing new relay on cable harness
-
Select the cable harness (P/N 9148756) supplied with kit
-
Attach the relay in the kit to the 5-pin connector which is attached to the same end of the cable harness as the black-red cable
B3
Attaching cable harness with relay
Cars without passenger airbag
-
Attach relay and cable harness above the beater vacuum reservoir, using a strip clamp.
Cars with passenger airbag:
-
Attach relay and cable harness to the plastic bracket near evaporator housing.
All cars:
-
Route the red-black cable inside the center console side panel to the central electronics module.
-
Connect cable to fuse 6 at terminal 4 on CEM.
-
Use Strip clamp to attach to existing cable harness.
Install cables from relay to connector.
-
Locate connector on cable between heater and dashboard (on side of center console).
-
Separate connector and connect connector halves, from the new cable harness to the existing for the respective model years:
Model year 1991: