940 L4-2.3L SOHC VIN 88 B230F (1992)
-
Connect the black-white cable included in the new cable harness to the ground plate on the right side of the cowl.
The ground plate is located behind the fuel control module.
B10
Route cables to engine compartment
-
Route cables without housing receptacles to engine compartment through unused outlet in grommet under brace to suspension strut (tower).
-
Attach the round housing receptacles included in the new cable harness on the cables in the engine compartment.
-
Separate existing connectors on the cable between the A/C compressor and the receiver/drier.
-
Connect cables from the new cable harness to the separated connectors
B11
Location of opening in cable sheath
The cable sheath is cut to drain off condensation.
-
The cut conduit section should be placed at the lowest point in the cable routing
Use butyl tape to seal the grommet
-
Use existing clamps to clamp up the cables to firewall
Function verification and information
B12
Check airing cycle is working