940 L4-2.3L SOHC VIN 88 B230F (1992)
-
Apply three butyl tape sections on the control module.
-
Install control module on dashboard side section with butyl tape.
B7
Connection and mounting control module in cars with SRS (Airbag) and knee bolster
-
Install control module on front of air duct under glove compartment with butyl tape and strip clamps round duct and control module as shown.
-
Clamp cable harness with 2 strip clamps in existing cable harness at side of SRS (Airbag) module one as near the connector as possible so that no
noise occurs due to vibration on uneven road surfaces.
B8
Fastening cables in cars without SRS (Airbag) and knee bolster
-
Clamp cables with 2 strip clamps in existing cable harness at side of SRS (Airbag) module one as near the connector as possible so that no noise
occurs due to vibration on uneven road surfaces.
B9
Connection of cable to ground plate
