940 L4-2.3L SOHC VIN 88 B230F (1992)
- Replace blower resistor and blower motor as shown for the model vanants.
- Reconnect battery ground lead.
- Reset radio code.
Carry out C2 in the same way for the model variants
C2
DRYING EVAPORATOR
- Set temperature control to max. heat and select max. blower speed with the blower switch.
- Start engine.
Allow engine to run for 2 minutes.
- Stop engine.
Allow spray to cure for 30 minutes.
- Start engine.
- Open car windows.
- Select recirculation, set temperature control to max. heat and select max. blower speed with the blower switch.
Allow engine to run for 20 minutes to permit coating to dry and form protective skin, and to prevent agent from being washed off by condensation.
C3
RECONNECT A/C COMPRESSOR
- Reconnect A/C compressor by reconnecting the compressor connector to the car cable hamess.
C4
Reinstall all other parts removed.
