940 L4-2.3L SOHC VIN 88 B230F (1992)
INSTALLATION OF CONTROL MODULE AND CABLES.
740 MCC model year 1988-90
A1
Preparations
-
Clean evaporator according to: Service Bulletin 8-87-948.
-
Make note of radio code if anti-theft coded radio installed.
Remove:
-
Negative battery lead.
-
Sound insulation on passenger side.
-
Glove compartment.
-
Cowl on passenger side.
-
Ashtray.
-
Cigar lighter.
-
Storage compartment.
-
Detach, pull out and turn central electronics module. Refer to Service Manual:
Section 3(35-39), Lighting, instrumentation and other electrical equipment (see Group 37)
700/900 1982-
TP 3502201
Section 8 (82-86, 88), Interior. exterior,
700/900 1982-
TP 8202201
CABLE CONNECTIONS
A2
Installing new relay on cable harness
-
Select the cable harness (P/N 9148755) Supplied with kit.
-
Attach the relay in the kit to the 5-pin connector which is attached to the same end of the cable harness as the black-red cable.
A3
Attaching new cable harness with relay
Attach relay and cable harness above the heater vacuum tank using a cable tie.
-
Route the red-black cable inside the center console right side panel to the central electronics module.