940 L4-2.3L SOHC VIN 88 B230F (1992)
Fig. 3 Checking gearshift linkage between positions Drive and Neutral.
Check that tangible clearance is felt when moving from position D to N and that clearance is equal to that when moving from position 2 to 1.
Tighten locknut if clearance is correct, torque: 17-23 Nm (12.5-17 ft.lb). If Clearance is incorrect, adjust as follows:
-
If Lever is stiff in position D: Adjust reaction arm approx. 2 mm towards rear.
Reaction Arm
-
If lever is stiff in position 2: Adjust reaction arm approx. 3 mm towards front. Distance between two marks (introduced on models from
1983 on) on reaction strut rear mounting is 2.5 mm. Tight en locknut. Torque: 17-23 Nm (12.5-17 ft.lb).
After Adjustment, Check:
-
that engine starts only in positions P and N
-
that reversing light operates in position R
NOTE: Reversing light may not operate in position R on some models. In this event, reduce the clearance between positions D and N by
adjusting the reaction arm slightly towards the front.