940 L4-2.3L SOHC VIN 88 B230F (1992)
10. Install gear selector shaft and cam. Always use new locking pin and retaining ring. Tap retaining ring into position over pin. Lock ring by punching
into recess beside pin.
11. Insert parking pawl pushrod in selector cam.
Retaining Plate
12. Support parking pawl with pushrod and install retaining plate. Torque: 69 Nm (4.5-6.5 ft.lb).
13. Mount selector link on gear selector shaft. Torque: 14 Nm (10 ft.lb).
14. Connect control rod to selector link.
15. Mount control system in position. Refer to "Hydraulic Control System Installation". See: Hydraulic Control System/Service and Repair
16. Check operation of mechanism.