940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Press in drive shafts until snap rings engage in grooves.
^
Check that rings are seated by pulling gently on CV joints.
Reconnect:
speedometer sensor connector
^
Check that upper front bushing half is seated in final drive.
Press final drive up against rear axle member
Ensure that bushing half is positioned inside guide edges on member.
Install:
-
holder 999 5580 at front of final drive and holder 999 5579 at rear of final drive
-
speedometer sensor lead in bracket on top of rear axle member, Remove:
-
unit hoist
Place rear axle member on unit hoist with universal fixture 999 5972
Ensure that joint surfaces on member are clean.
Press member upward
Install:
-
new bolts. Do not tighten.
Remove:
-
unit hoist
