C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Lubricate a new drive shaft screw. Screw it in a few turns by hand.
Clean off any rust from the ball joint and wheel spindle.
Lubricate the ball joint pinion. Lubricate the wheel spindle.
Install the ball joint in the wheel spindle
NOTE: Press the ball joint upwards so that the conical top is visible above the screwed joint on the wheel spindle.
Install the screw and a new nut.
-
Tighten to 50 Nm.
Check the dust boot on the anti-roll bar link for damage.
Check the threads on the link for damage. Lubricate the threads.
Install the upper link of the anti-roll bar on the spring strut. Use a new lock nut. Tighten to 50 Nm.
Install the tie rod on the wheel spindle. Use a new lock nut. Tighten to 70 Nm.
Check that the brake disc mating surfaces with the wheel bearing unit are smooth and even.
Install
-
the brake disc
-
the locating pin for the brake disc. Tighten to 8 Nm.
