S60 L5-2.4L VIN 64 B5244S6 (2003)
Install the inlet pipe for the coolant pump on the cylinder head. Use a new gasket.
Note! Apply thread sealant, P/N 116 056, to the screw threads.
To clean the shaft journal and mating surface, use emery cloth P/N 951 1024.
Note! Cleaning shall be done in the direction around the shaft journal, not in and out. It is very important that any residue from the emery
cloth or any other contaminants are completely removed before the new seal ring is installed.
Installing the rear camshaft seal
Use drift 999 5450 PUNCH See: Tools and Equipment/999 5450 Punch.
Lubricate the surface of the seal that the camshaft rotates against.
Press in the seal until the drift bottoms out.
Note! If there are wear grooves on the camshaft the seal can be pressed in another 2 mm, by turning around the tool's sleeve.
Install camshaft adjustment tool 999 5452 CAMSHAFT ADJUSTMENT TOOL See: Tools and Equipment/999 5452 Camshaft Adjustment Tool at the
rear of the camshafts.
Check that the screws securing the adjustment tool to the camshafts and the screws holding the tool together are well tightened.
