S60 L5-2.4L VIN 64 B5244S6 (2003)
Install:
-
a new gasket held in position by the lower intake manifold screws
-
the intake manifold
-
the crankcase ventilation. The crankcase ventilation must be installed through the gap between the second and third channels
-
the hose for the Positive temperature coefficient (PTC) nipple
-
the lower screws. Tighten all the screws
-
the screw at the support bracket (under the intake manifold).
Install:
-
all 4 vacuum hoses on the intake manifold. (See the illustration)
-
connect the connector on the Positive temperature coefficient (PTC) nipple for crankcase ventilation (5).
Installing the fuel and air distribution pipe
-
Install the fuel rail and injector nozzle
-
Press the quick-release connector together until a clicking sound is heard. See Fuel line, lock See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Rail/Service and Repair. Use new screws and tighten.
Install:
-
the connectors on the injectors and manifold absolute pressure (MAP) sensor in the fuel line and Positive temperature coefficient (PTC) nipple
-
the connector to the throttle body (TB).
Install:
-
the cover plate over the injectors
-
the crankcase ventilation hose on the top of the camshaft cover. Use a new clamp
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the cover over the ignition coils
-
the dip stick in the intake manifold
-
the clip for the power steering delivery line
-
the ignition coils according to the earlier markings. Check that the connectors for the ignition coils are secure
-
the screws for both the ground terminals between the ignition coils.
Installing the exhaust manifold
Install new gaskets.